G. FENCING
Facilities that are to be enclosed by security fencing shall have the fencing located on the interior of the buffer area. Solar facilities that do not coincide with livestock shall use wildlife-permeable fence, fencing with larger holes than a traditional chain-link fence that allows for small-to medium sized animals to move freely through the fence for at least ten percent (10%) of the fence lines where the ten percent (10%) shall be evenly distributed along each quarter mile section and at identified wildlife corridors. Wooded areas of ten (10) acres or greater must be incorporated into wildlife corridors so that fencing does not prevent access to the wooded area by large animals. Substation locations identified on the site plans will be allowed to use traditional chain-link fencing around the entire structure. Fencing shall be maintained in good condition for the life of the solar facility operation. Barbed wired fencing is prohibited as the sole type of fencing. Barbed wire may be used in conjunction with other approved fencing.
H. GROUND COVER
The ground around and under solar arrays and in buffer areas that do not contain concurrent agricultural uses shall be planted and maintained in native perennial vegetated ground cover, and meet the following standards:
I. LIGHTING
Lighting must meet the requirements in ARTICLE XXX, Section 5 DEVELOPMENT STANDARDS.
J. GLARE
Solar panel placement should be prioritized to minimize or negate any solar glare onto nearby properties or roadways, without unduly impacting the functionality or efficiency of the solar system. Exterior surfaces of the collectors and related surfaces shall have nonreflective finish.