305.6 Interior doors.

Every interior door shall fit reasonably well within its frame and shall be capable of being opened and closed by being properly and securely attached to jambs, headers or tracks as intended by the manufacturer of the attachment hardware.

SECTION 306

COMPONENT SERVICEABILITY

306.1 General.

The components of a structure and equipment therein shall be maintained in good repair, structurally sound and in a sanitary condition. These requirements shall apply to interior but not to exterior stairways, landings and balconies unless they are more than (ten feet) 10’ higher than the grade below. The code official may grant an administrative variance from this exterior requirement, on his own motion or on request of the property owner, so as to increase the ten feet (10’) height by up to 20%, if the facts are such that the code official makes the same written conclusions of fact that are required by Section 107.2(D) for variances.

306.1.1 Unsafe conditions.

Where any of the following conditions cause the component or system to be beyond its limit state, the component or system shall be determined as unsafe and shall be repaired or replaced to comply with the International Building Code or the International Existing Building Code as required for existing buildings:

1. Soils that have been subjected to any of the following conditions:

1.1. Collapse of footing or foundation system.
1.2. Damage to footing, foundation, concrete or other structural element due to soil expansion.
1.3. Adverse effects to the design strength of footing, foundation, concrete or other structural element due to a chemical reaction from the soil.
1.4. Inadequate soil as determined by a geotechnical investigation.
1.5. Where the allowable bearing capacity of the soil is in doubt.
1.6. Adverse effects to the footing, foundation, concrete or other structural element due to the ground water table.

2. Concrete that has been subjected to any of the following conditions:

2.1. Deterioration.
2.2. Ultimate deformation.
2.3. Fractures.
2.4. Fissures.
2.5. Spalling.